I have a complete alpha setup from my 87 Baja Force 235
transom assembly is complete inner and outer setup,
with steering components

First outdrive is complete with driveshaft which has the following newly installed with 0 hours on them
new driveshaft yoke
2 new cross bearings
bearing retainer
yoke seal carrier
yoke nut
fresh mercruiser drive fluid
small repair that was professionally tig welded by a local marina, not on any fluid passages,
drive is 100% complete just pulled off the boat,
everything was replaced literally about 2 months ago, and this drive has zero hours on it
outdrive will need some paint on it

2nd outdrive is complete minus the driveshaft,
this was my spare unit, that I never ended up using has about 20 hours of use on it,
paint is in good shape,
nothing wrong with it at all
I had it saved for a spare, but ive decided to switch over to a Bravo setup

complete alpha transom assembly which has the following newly installed with 0 hours of use
gimbal bearing
u joint bellow
complete inner and outer transom with all sterring lines, trim tab sender and limiter,
water hoses
steering setup
could use a fresh coat of paint

Im switching over to a Bravo setup so I would like to sell this stuff off to help pay for the Bravo swap,
looking to get around $1350 for everything will seperate if needed
if anyone is interested please pm me or email me at
blkstang0321@yahoo.com
located in Seaford, NY (on Long Island south shore)
thanks