Page 1 of 2 1 2 LastLast
Results 1 to 20 of 30
  1. Collapse Details
    JBS Racing Miami SERIOUSOFFSHORE Press Release
    #1
    First, Team JBS Racing piloted by Jeff Stevenson Driver/Owner, Throttled by Joe Skrocki, and the entire JBS Crew, would like to apologize for our delayed response surrounding the APBA/SBI Miami Offshore Race. For those that are not aware; Team JBS Racing only had a half of a lap remaining to complete and win the race with a substantial lead over second place. Some even thought JBS Racing had won the race. Unfortunately this was not the case. Team JBS Racing made a TEAM decision to stop. This was due to the boat rapidly taking on water and resulting in the partial sinking of the boat. We did not crash unexpectedly. We never took a hit that did more damage than a previous wave and or lap. We never were in fear for our safety as all the events that took place were very calculated as a TEAM. We understood there would be many questions afterward from every angle. What we did count on was the rate at which they were going to be asked.*

    Unlike any other offshore race team in the world, Team JBS Racing has some amazing resources that are unrivaled in Offshore Powerboat Racing. This is partly due to Unlimited Offshore Racing having no rules in place limiting the team's capabilities. JBS Racing has the unique opportunity of having an onboard data acquisition telemetry system. Turbine Marine, who built the engines and rigged the boat, are analyzing all vital parameters real-time as we are running and/or racing. Our crew was in various strategic points on the race course, one of them being from a high point where the complete course could be viewed. This allowed Team JBS Racing to have complete verbal communication with all of those points as well as with the boat at all times. It also allowed complete video to be recorded and monitored to insure the external elements of the boat were monitored at all times. This system allowed complete data communication as one person viewed the boat's parameters and another to interpret events. There are over 10 video recorders in very well placed areas in the boat recording vitals such as drive shafts, oil levels, and 360 degree views of the boat externally and internally.

    To the point; There was a slight amount of cosmetic damage the boat sustained in the first 3 laps while Team JBS Racing took the lead and held it. In fact, the cosmetic damage was much less than it sustained in the Key West World Championships in November 2008. We then lowered the pace as every other race boat did in an attrition type of race condition. The damage did not increase at any alarming rate as the high power hi definition cameras were recording real-time at all points. The only exception was at one point during the race we agreed to pick the speed back up for data acquisition purposes ONLY. As in anything, but more true when speaking of racing, hind sight is 20/20. Our hind sight...We slowed in the corners too much to insure the win. As low as 40 mph at times around the corners to give the Super V’s more than extra room to complete their battle. This placed higher loads on the non-running surface where the effected area was located. The area was completely cosmetic until coming back toward shore and passing the start/finish line. At that point we got the first report that the area was now on the running surface. After slowing even further, there was still no water intrusion into the boat. Water intrusion occurred after start/finish line and took under 5 seconds from breach for the boat to fill with water. Jeff and Joe remained calm as both turbines were kept running as they are good water pumps. As the water level increased on the starboard side, the engine was shutdown manually and allowed to free spool to a complete stop. The port remained running and completely free of any water. Jeff shutdown the port side manually, as Joe was in the bilge manually pumping water and assessing the damage to both hull and engines. Jeff could feel the boat taking on more water and pulling too hard to continue running the port engine. The port engine also freely and completely spooled to a stop.

    Safety patrol and David DiPetrillo, who we also consider a direct part of Team JBS Racing, were right there as well as multiple tow services. This is not the only time Team JBS has had experience preventing a boat from sinking, or recovering a boat off the bottom ourselves. At the 2005 Miami Offshore Race the JBS Racing Super-V sank to the point the drives were touching the bottom while Joe and Jeff were still in it. The circumstances could not have been more alike surrounding the tow companies. Fortunately, Joe and Jeff were able to jump on the boat owned and operated by the owner of Offshoreonly, Steve Schuble. Joe, using the tanks from the safety divers and working with Steve, had many failed attempts at righting the upside-down Super-V due to inadequate tow ropes and equipment. Many tow companies were surrounding the vessel like vultures. Jeff, as the owner of the Super-V, gave Schuble*the authority to broker a deal to get the boat back to the crane and out of the water at a set price. Many came and went as only one company agreed to a set price, and that IT WAS NOT A SALVAGE JOB though the races were long over at this point. During the race, the racing organization has a permit from the US Coast Guard and it becomes their territory. Team JBS Racing has been there and done that! The JBS Mystic was on the hot race course and was connected to a tow company vessel using JBS equipment that was connected by Joe. The tow company did not want the Mystic connected in the configuration that ultimately saved the boat from sinking completely. The tow company was convinced the JBS boat would sink them. Entering the cut, after serious progress had been made, the tow company wanted to let the boat sink and return later when there was less chance of sinking their own boat. They did not want the US Coast Guard involved stating, "They would roll the boat and sink everyone if they followed the well thought out plan JBS Racing had given". The USCG Captain agreed with the JBS Racing plan.*

    To say the least, the deal from the towing company changed once the boat was on the trailer, citing circumstances labeling it a salvage. All issues surrounding the tow were addressed on shore with key witnesses present. The bill was paid in full by JBS Racing. The only reason being, Team JBS Racing, is not out of the 2009 National Championship Races yet!*

    You know how Team JBS Racing rolls....Bigger, Better, Faster!

    A special thanks to ALL the race teams present, as everyone came together and really made it happen for Team JBS Racing!
    Reply With Quote
     

  2. Collapse Details
     
    #2
    Did ya at least get a chance to punch the dude in the teeth? glad everyone was safe...
    Reply With Quote
     

  3. Collapse Details
     
    #3
    Welcome to SOS!

    I wish you joined under different circumstances, however am grateful you are here (as in safe from the incident) and grateful you are here (SOS)!

    Thank you for sharing and hope you get your rig righted before the next race!
    Reply With Quote
     

  4. Collapse Details
     
    #4
    Charter Member boatme's Avatar
    Join Date
    Oct 2008
    Location
    Michigan
    Posts
    1,325
    Joe,

    Glad to hear all is good

    I am attaching some pictures i pulled from another site that had them posted

    From the damage i would say you guys handled this ordeal very well

    Good luck and cant wait to see you guys out there again

    Credit for the pics go to RCHEVELLE71 of speedwake
    Attached Thumbnails Attached Thumbnails p5210055.jpg   p5210056.jpg   p5210057.jpg  

    Last edited by boatme; 04-22-2009 at 06:49 AM.
    Reply With Quote
     

  5. Collapse Details
     
    #5
    Charter Member boatme's Avatar
    Join Date
    Oct 2008
    Location
    Michigan
    Posts
    1,325
    more
    Attached Thumbnails Attached Thumbnails p5210058.jpg   p5210059.jpg   p5210060.jpg  

    Reply With Quote
     

  6. Collapse Details
     
    #6
    Registered DollaBill's Avatar
    Join Date
    Oct 2008
    Location
    Worldwide - Blue Martini Hall of Fame - Your sisters house
    Posts
    2,740
    Can you please clarify one statement?

    "Putting higher loads on the non-running surface" Umm, the entire stbd side is GONE. I saw the first pic's which showed (regardless of cause) a hole very close to the bow, but the final pics show damage almost all the way back.
    Reply With Quote
     

  7. Collapse Details
     
    #7
    registered
    Join Date
    Oct 2008
    Location
    St. Petersburg, FL
    Posts
    3,965
    Thanks for the report! Glad to have you guys on SERIOUSOFFSHORE!

    Reply With Quote
     

  8. Collapse Details
     
    #8
    registered
    Join Date
    Oct 2008
    Location
    St. Petersburg, FL
    Posts
    3,965
    Welcome new member JBS Crew.

    Reply With Quote
     

  9. Collapse Details
     
    #9
    Can someone explain the different layers of the hull?

    Gelcoat is white (?)
    Carbon is black (?)
    Then?
    Reply With Quote
     

  10. Collapse Details
     
    #10
    Quote Originally Posted by MarylandMark View Post
    Can someone explain the different layers of the hull?

    Gelcoat is white (?)
    Carbon is black (?)
    Then?
    did you read the answer the last time you asked?

    paint (epoxy boat)/carbon (outer and inner skins)/herex (pvc core)
    Reply With Quote
     

  11. Collapse Details
     
    #11
    Quote Originally Posted by Dollabill View Post
    Can you please clarify one statement?

    "Putting higher loads on the non-running surface" Umm, the entire stbd side is GONE. I saw the first pic's which showed (regardless of cause) a hole very close to the bow, but the final pics show damage almost all the way back.
    I would think It makes perfect sense that if the breach was near the bow it would continue to run down the sponson "front to rear" once the separation occurred due to the water pressure being exerted on it while moving forward at speed or while turning...
    Reply With Quote
     

  12. Collapse Details
     
    #12
    Registered DollaBill's Avatar
    Join Date
    Oct 2008
    Location
    Worldwide - Blue Martini Hall of Fame - Your sisters house
    Posts
    2,740
    Quote Originally Posted by nortech4play View Post
    I would think It makes perfect sense that if the breach was near the bow it would continue to run down the sponson "front to rear" once the separation occurred due to the water pressure being exerted on it while moving forward at speed or while turning...
    I would normally agree, but he mentioned speeds "as low as 40 mph"
    Reply With Quote
     

  13. Collapse Details
     
    #13
    Registered purrfection's Avatar
    Join Date
    Nov 2008
    Location
    THE GULF COAST
    Posts
    334
    Thank you for clearing up the rumors. It's a shame this had to happen , when you are starting to hit your stride with more time in the boat. Best of luck to All of the JBS team and hurry and get the boat fixed, so we can see back where you belong, in the lead.
    Reply With Quote
     

  14. Collapse Details
     
    #14
    Founding Member / Competitor
    Join Date
    Oct 2008
    Location
    Lake Travis Texas
    Posts
    6,844
    Quote Originally Posted by Dollabill View Post
    I saw the first pic's which showed (regardless of cause) a hole very close to the bow, but the final pics show damage almost all the way back.
    Once there is an opening in the running surface and the water has an entry point the water will continue to expand the effected area. It is like a hydraulic pump forcing the parts to separate. Hydraulic pressure is very effective as you can see once it finds its way in it will tear everything to pieces all the way back. This is not the first time some thing like this has happened.
    Reply With Quote
     

  15. Collapse Details
     
    #15
    Registered H2O Full Throttle's Avatar
    Join Date
    Feb 2009
    Location
    Auckland, New Zealand
    Posts
    198
    Just a quick question Joe, you guys paid a $hitload of money to Mystic for a high performance race boat, I would have expected that the finished product would have been able to perform as expected in conditions like this. ???

    Ned
    Reply With Quote
     

  16. Collapse Details
     
    #16
    Founding Member / Competitor
    Join Date
    Oct 2008
    Location
    Lake Travis Texas
    Posts
    6,844
    I just read Mystic, John Cosker's response in the JBS press release thread. He is going to replace the boat. You can find his post on page 8.

    As stated above I am going to stand behind my product and put Joe and Jeff into a new boat. They are meeting with John Arruda today to go over the rigging transfer details.
    Reply With Quote
     

  17. Collapse Details
     
    #17
    Registered H2O Full Throttle's Avatar
    Join Date
    Feb 2009
    Location
    Auckland, New Zealand
    Posts
    198
    Now that is a class act. Very honourable.
    Reply With Quote
     

  18. Collapse Details
     
    #18
    Founding Member / Super Moderator Ratickle's Avatar
    Join Date
    Oct 2008
    Location
    West Michigan
    Posts
    37,972
    Blog Entries
    45
    Quote Originally Posted by MOBILEMERCMAN View Post
    I just read Mystic, John Cosker's response in the JBS press release thread. He is going to replace the boat. You can find his post on page 8.

    Quote:
    As stated above I am going to stand behind my product and put Joe and Jeff into a new boat. They are meeting with John Arruda today to go over the rigging transfer details.



    Quote Originally Posted by H2O Full Throttle View Post
    Now that is a class act. Very honourable.
    That is without a doubt the truth....
    Getting bad advice is unfortunate, taking bad advice is a Serious matter!!
    Reply With Quote
     

  19. Collapse Details
     
    #19
    Registered DollaBill's Avatar
    Join Date
    Oct 2008
    Location
    Worldwide - Blue Martini Hall of Fame - Your sisters house
    Posts
    2,740
    Quote Originally Posted by MOBILEMERCMAN View Post
    Once there is an opening in the running surface and the water has an entry point the water will continue to expand the effected area. It is like a hydraulic pump forcing the parts to separate. Hydraulic pressure is very effective as you can see once it finds its way in it will tear everything to pieces all the way back. This is not the first time some thing like this has happened.
    I hear what you're saying and not going to beat the horse any further. It just surprised me a little. Thats all
    Reply With Quote
     

  20. Collapse Details
     
    #20
    John Cosker and Mystic are standing behind their product.
    Reply With Quote
     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •