Help 454

[MiamiOffshore]

I have a stock mercruser 454/330hp with a mercII trans and trs drive.
I have to rebuild the motor but was wondering if a Small Block will bolt straight up to the bellhousing?
I would just need to adjust motor mounts and change out exhaust right?
I would like to get it running and I have a small block chevy sitting around so I was thinking of throwing it in there with stock exhaust so I can take my time with the BBC build.

[MOBILEMERCMAN]

GM SB and BB have the same bellhousing pattern..You may not have to adjust the mounts.. Something important you should be aware of.. The Merc trannie relies on a pilot bushing in the crank end to align itself to the engine.. Make sure it is in the small block or the trannie will fail. Also verify the locating dowels in the block are there too.

[fixxxer22]

GM SB and BB have the same bellhousing pattern..You may not have to adjust the mounts.. Something important you should be aware of.. The Merc trannie relies on a pilot bushing in the crank end to align itself to the engine.. Make sure it is in the small block or the trannie will fail. Also verify the locating dowels in the block are there too.

I did not know as much as he said above but i do know they have the same bellhousing pattern. good luck with her!

[htrdlncn]

better be a strong small block to move a 24 with a TRS..

[Slandrew]

better be a strong small block to move a 24 with a TRS..

[DAREDEVIL]

better be a strong small block to move a 24 with a TRS..

too, but hey you can get 600 HP out of a SB ..lol

[MiamiOffshore]

better be a strong small block to move a 24 with a TRS..

Guys just looking to keep it going while I build the BBC I know it's not going to be any sort of speed demon.

[DAREDEVIL]

Guys just looking to keep it going while I build the BBC I know it's not going to be any sort of speed demon.

We are just messing with ya...we know..lol



BTW, i have a 510 Ci gen IV block here ( chevy bowtie ) !!!!!