Looking for a used IMCO shorty if anyone has one available. I need it to be 1.5 gears....Thanks
Thread: WTB..2" IMCO Shorty
Results 1 to 10 of 10
-
10-23-2009 08:34 AM
-
- Join Date
- Oct 2008
- Location
- West Michigan
- Posts
- 37,372
- Blog Entries
- 44
10-23-2009 08:35 AMWelcome Wayne.
What have you got? And where in Mid Mi are you????Getting bad advice is unfortunate, taking bad advice is a Serious matter!!
-
-
- Join Date
- Oct 2008
- Location
- West Michigan
- Posts
- 37,372
- Blog Entries
- 44
-
10-23-2009 08:56 AM
Hey Wayne. Glad to see you made it over here.
-
-
-
- Join Date
- Oct 2008
- Location
- West Michigan
- Posts
- 37,372
- Blog Entries
- 44
-
-
10-29-2009 06:26 PM
Hey Wayne,
We have your answer! I can build you the strongest "XR" lower w/ a IMCO -2" satin case w/ any choice of gear ratio for $5,157.25 ready to install. We Use the IMCO Case, Mercury Gear sets (1.5:1, 1.35:1, 1.26:1), TCM verticle Shaft, TCM Prop Shaft, TCM Carrier, and the good bearings! You are also going to need a S.S. cav. plate. Our drive techs have been building drives for high HP for 10+ years, and know and understand the correct set-up.
Beware of the used lowers. If you do buy one, sent it to a reputable company who builds and serivces these drives to have it gone through. Chances are you are going to be replacing parts before you even use it, which could easily cost more than a new one! -Eric
"We Have Everything But The Water!"