http://www.gbfiberglassparts.com/consoles.aspx
Now turn Matlock off and get back to drinkin
Thread: console repair question
Results 21 to 33 of 33
-
01-01-2009 08:26 PM
-
- Join Date
- Oct 2008
- Location
- West Michigan
- Posts
- 37,877
- Blog Entries
- 45
-
01-01-2009 08:36 PM
I would take a differant approch. Use a ball pein hammer to do simmilar damage to the other corners, and start drinking more!!
Taking Over the World One Thread at a Time
The Penguin Cometh
-
-
- Join Date
- Oct 2008
- Location
- West Michigan
- Posts
- 37,877
- Blog Entries
- 45
-
-
-
- Join Date
- Oct 2008
- Posts
- 4,796
-
- Join Date
- Oct 2008
- Location
- Edgerock, MD
- Posts
- 1,947
-
01-01-2009 11:42 PM
Mitch welcome aboard but ................................ if i were to express my knowledge of over 30 years doing fiberglass repair on SPEEDWAKE , i would be told it was a form of advertising , so with that in mind , if anybody would like me to talk them thru gas tank repair,s on there Skaters ,structural , or anything related to fiberglass repair , feel free to PM me ................ G G
-
01-01-2009 11:52 PM
Thanks for the compliments, everybody!
I'm still a moderator on Speedwake, too. Jeff and Karen are very close friends of mine. I don't see any problem with helping out here in the tech section, too. I'm just trying to help.
Offshore Ginger, your method is probably the best, I'll admit. There are several ways that would be appropriate to this repair. This isn't really a traffic area or a structural integrity issue, so I wouldn't worry too much about the true strength of this repair. Granted, it is on a corner where it may get stepped on inadvertantly, which is probably how the damage occurred in the first place. It was probably also laid up too thinly in the mold, also. So the combination resulted in what you see here.
As long as the cracks have been dremeled or routered out into virgin territory, and there has been a sufficient aggressive grit applied to the repair surface area, any of these methods will probaby be sufficient.
I like to advise people that are trying to do their own repairs by using materials that they are familiar with and are readily available and inexpensive. I always worry when a person has to start buying the minimal amounts of repair items and is only going to use a teaspoon of bondo or 3 square inches of matte. They have to buy a whole blanket of matte and a quart of resin, etc. By the time they are finished, they've spent $200 on a repair and used $10 in materials from it.
Usually, I offer to send the paint materials in a fractional setup (like 2 0z. bottles, etc.) as a kit for the paint side of it, just to help the owners out. That's why I like to coach them thru the process on the phone. It's so much easier and less time consuming.
I hope this helps out.
-
01-01-2009 11:59 PM
That's totally true OG. And that is exactly how it is handled on SW, too.
So to clarify your concern, I was asked a few weeks ago by the staff here on Serious Offshore to come aboard and act as a Tech expert and assist GlassDave in this section of the forum. I also am advertising on this website and have contributed product as giveaway items, etc. in order to help support this website.
I hope that answers your statement sufficiently. I am looking forward to helping anyone that has a need for it.
Mitch
-