I have a skeg that is very obviously warped. Anyone know the best way to straighten it?
Thread: Skeg repair
Results 1 to 11 of 11
-
05-17-2010 01:40 AM
-
- Join Date
- Nov 2008
- Location
- Where the summer never ends
- Posts
- 4,346
-
-
05-17-2010 08:08 AM
yes seriously. its about a $70 job. but have some one do it thats does them all the time. Like your marina if they do that work
-
05-17-2010 03:27 PM
Cut and Paste!
Don't bend it back otherwise it could fail when under power and cause prop damage!
Cut and paste, Merc sells replacement weld on skegs!
-
05-17-2010 11:04 PM
Will do. Thanks guys!
-
- Join Date
- Oct 2009
- Posts
- 20
05-18-2010 06:33 PMI straightened two of mine recently with a large metal clamp. Put the clamps on and gave it a little turn every few days, Worked perfectly!
-
- Join Date
- Oct 2008
- Posts
- 4,796
05-19-2010 09:37 AMI guess it depends on the drive and the boat's usage. If it were something fairly low-performance it would be OK. But keep in mind that the skeg is a very highly stressed part- when turning. It is how it is right now for some reason. Now if you hit something with your cruiser and bent/broke it that's one thing. But if you bent it by turning hard, it's telling you something.
It's not uncommon for raceboats to bend or even snap skegs off. Lowers don't last forever. It's a highly stressed item. And welding repairs have issues. The weld isn't going to be as strong as the original. And often you get warpage in the case.
What you really need to consider is what's going to happen if you get a failure in a hard turn. Do you really want to chance a spin or roll at speed with a boat full of passengers?
-
05-19-2010 02:12 PM
saw a guy spin out once in a cat. he was screwing around doing sharp turns and just being cocky. dont know if the skeg broke off before or after but when it tossed him out and the boat kept going the skeg was for sure broken once it was stopped bu the shoreline.
Now recruiting Mississippi power boaters.
-
- Join Date
- Nov 2008
- Location
- Traverse City, Mi
- Posts
- 518
05-20-2010 04:14 PMIf you're not racing or doing a lot of high speed sharp turning find a very good reputable welder. I've damaged skegs by hitting rocks with both my outdrives over the years. Both skegs were replaced by a very good welder and I've run the boat a lot of hours since without a failure.
There is a replacement skeg which requires the complete old skeg to be removed plus the the lower gear set removed and the housing is kept cool to prevent warpage during the welding.
-
05-21-2010 11:43 AM
If you have a new one welded on, just make sure they tig weld. Mig welding the skeg on is not good enough. It doesn't make enough heat and the weld will usually fail. You really should disassemble the lower to properly weld the skeg on. If you don't, be careful to keep the seal area cool so as not to damage the seal.
Eddie