Has anyone heard of or experienced any deterioration or damage to a post 2004 496 with the Pro-Charger upgrade? 3lb or 5lb?
Thread: Pro-Charger on a 496
Results 1 to 9 of 9
-
12-19-2008 08:32 PMhttp://www.marineandspeed.com
Performance & reliability through comprehensive service
-
12-19-2008 09:21 PM
Haven't heard of many that haven't had problems. Just not a good platform to supercharge. They obviously do better with only 3 psi boost. At 5 psi, you are asking for trouble. I could not even estimate how many I have seen and heard about blowing up. The problems are not only with a Procharger, they are breaking with any SC. They were just not made for it.
Eddie
-
12-19-2008 09:32 PM
Thanks, that's about what I expected.
http://www.marineandspeed.com
Performance & reliability through comprehensive service
-
12-23-2008 09:34 AM
I have heard that the top ring is too close to the top of the piston. Too much boost or a little bit of detonation is all it takes to melt that thin area of the piston. No more than 3 lbs. of boost if you do it.
-
12-24-2008 10:18 AM
There are a lot of rumors out there about putting boost to a 496. I have knowledge of both. So below is my opinion. Also I will say right up front that obviously forged internals would be better & are still better than cast. So that aside.......... :
I have a whipple on my own 496 mag ho running 5-6psi. I am going into my 3rd season with it running strong. That said the whipple kit is much more precise over the PC. I also am running an auxillary oil cooler & much larger heat exchanger on my ap with some other stuff. However the internals are stock.
As far as the procharger on a 496 I am not a big fan of it due to it lack of being precise. Also they only have a listing for up to 04 on it. The lack of a proper ecm cal & boost sensor certainly make it all the more risky on it from ATI. However if you were to remap & use larger injectors and a boost sensor instead of just a map one would be better off.
There is a bit more to it than that on both of these kits, but those are at least most of the basics from the top of my head.
Jamie / Lakeside
-
12-24-2008 06:32 PM
I was figuring at the very least I would have to tweak the ECM's, utilize the Whipple ecm upgrade with the Pro-Chargers. However I am leaning more towards the complete Whipple package now rather than the Pro-Chargers. Thanks for the input.
http://www.marineandspeed.com
Performance & reliability through comprehensive service
-
12-24-2008 06:47 PM
No problem & your'e welcome. Also again IMO yes the Whipple is a MUCH better way to go on the 496 platform for sure.. Jamie / Lakeside
-
- Join Date
- Nov 2008
- Location
- San Diego
- Posts
- 102
12-31-2008 02:38 PMIf you have to supercharge a STOCK 496, Jamie at Lakeside is correct, the Whipple is the only way to go. Whipples ECM re-programs and properly calibrated fuel delivery system will give you the best performance and hopeful reliability. A Pro-Charger system without custom programming and special set up in the boat is a recipe for disaster!
If you want to still run 87 octane fuel and have better reliability, longevity and close performance gains then you should consider our Raylar 525HP -103 kit.
Be careful, do it right with expert help and you will have a better overall upgrade expierence! Boat safe and enjoy!
Best Regards,
Ray @ Raylar
-
12-31-2008 09:29 PM