Looking for 2 clamp on mufflers for 4 1/2" tailpipes for Stellings headers. Have manual switching Gaffrigs where when muffler is on water comes out the bottom. These do not quiet boat whatsoever. Tail pipe has signature Stellings 90 degree water separater tube (water and exhaust separate). What will help noise...sure to get a ticket. Was thinking ggb, gibson, or Zoomers...any suggestions?
Thread: clamp on mufflers
Results 1 to 8 of 8
-
- Join Date
- Nov 2009
- Posts
- 107
04-13-2010 12:35 PM
-
04-13-2010 09:17 PM
I've had the best results with GGB. They took a break from the marine market for a while but they are back in full swing.
Check 'em out. I highly recommend them.
Kurt
http://ggb.ca/
-
- Join Date
- Nov 2008
- Location
- Where the summer never ends
- Posts
- 4,346
-
04-13-2010 10:47 PM
I've used the shotgun silencers by Drew marine, work at idle and open up under power
http://www.drewmarine.com/products/shotgun/shotgun.htmlRun until it sounds expensive
-
- Join Date
- Nov 2009
- Posts
- 107
-
04-20-2010 07:35 PM
I had these clamped on to my stellings dry tails. They are air operated, and REALLY quiet it down. I know what your saying about the basic downfiring ones not doing much. Flipping them closed cruising at 3200 rpm, it went from being annoyingly loud, to super quiet with just a nice tone. I highly recomend these. THey are gaffrig superflow series.
-
- Join Date
- Nov 2009
- Posts
- 107
-
04-20-2010 10:19 PM
I have two new cmi muffers one set only owner did not like the look with them on $550