Things may change seeing as I now have 4 person canopy mold, but either way the single F-16 lid had to be removed and the tube widened 7 inches on each side to allow enough room for a side by side configuration.
Results 1 to 20 of 420
-
02-01-2010 08:22 AM
-
-
02-01-2010 08:26 AM
Once everything was cut clear we removed the F-16 Canopy, It was pretty heavy - I was a little surprised.
-
-
02-01-2010 08:28 AM
I'm really shocked how thick this hull/deck is.. In some areas it's 1 1/2- 1 3/4
-
02-01-2010 08:29 AM
The boat is scary solid ! Oh' and I have 2 80 gal fuel tanks for those 500 mile offshore races.
-
02-01-2010 08:31 AM
Next we removed all the rigging and cut the lip back to exposed the tube completely
-
02-01-2010 08:33 AM
The fuel tanks actually sit 2 inch's higher than the bottom of the floor, so this will require us to build a "sub floor" witch will not be so bad because I can run all the rigging under it
-
02-01-2010 08:38 AM
All this work was done on Sunday (8hrs) so I feel we got a pretty good jump on the project, but with work and another race boat this is going to take a while.
Once I rebuild a larger tub I'll look into the 4 person skater canopy I have, If I feel it cannot be attached safely and securely I will attach a fairing I have off another cat and graft that in.
-
- Join Date
- Oct 2008
- Location
- ROCHES POINT ONTARIO
- Posts
- 1,339
02-01-2010 09:10 AMAnother great build project !!!!!!!!!!!!
-
-
- Join Date
- Feb 2009
- Posts
- 12
02-01-2010 11:29 AMRick, I am glad you finally committed to that project, it was a long time comming !!
-
-
- Join Date
- Oct 2008
- Posts
- 2,001
02-01-2010 12:04 PMSparky! Long time, no see bud! Hope all is well.
Cool project Rick, amazing what you find once you start cutting into these things.
-
02-02-2010 12:24 PM
Last night after work I finished opening up the cockpit to the needed size.
-
02-02-2010 12:26 PM
I than "mocked up" some cardboard to the angles I would like the windscreen or canopy lid if I go that route.
-
02-02-2010 12:28 PM
after placing a couple 2x4 across the opening to give my seats a flat surface to sit on I'll start setting seat height and position
-
02-02-2010 03:09 PM
Can I just say BOOOOO! And good luck! Looks like it's coming along nicely.
"Tear gas and draft beer don't mix."
-
-
02-02-2010 03:27 PM
cuttin' apart boats is fun!