nice pad!
dont know what happened but Ban rebuilt my trannies to drysump for around 4k good as new..
Thread: Mercury Refresh of Transmision
Results 21 to 40 of 40
-
- Join Date
- Nov 2008
- Location
- KY Lake Paducah KY
- Posts
- 54
11-13-2009 11:47 AM
-
11-13-2009 12:44 PM
In a nut shell, refreshed trannies through Mercury (they said they have new ones on the shelf and just swap them out, and I swear this is what they told me) 8 hours into use and I admit running hard (pretty much same as I always drive though) broke tranni, second trannie (new one sent and paid for) broke on hose, third one (new one sent and paid for) broke on hose, inspected this one and bad ring instalation caused it and had it repaired by another shop and put in the fourth trannie and all has been good since (30 hours). Just lost all of July and engine had to come out each time. Paid for all R&R's and all S/H and new trannies, mercury refresh of trannies, and repair.
No concessions... Just bend over and it is what it is...
-
11-13-2009 12:53 PM
Defense I was given...
First one is Mercury's problem, second the cooler was not cleaned properly, third one should of been sent back for evaluation so no comment.
All I wanted was to boat so I wasn't going to wait around for possible warranty. Just send me a new one and once you decide on warranty let me know. Diddn't plan on two new ones breaking after the first one.
-
11-13-2009 01:01 PM
In all my boating...The transmission issue is the only thing that still resinates the same as when it happened.
Just thought it was unfair, and I guess so much so that 6 months later it still irritates me. God willing I have a lot of high performance boating left and will enlighted people as much as possible on just this situation.
Otherwise I'm truly impressed with everything else on my cig as far as quality. Eventally when the oppurtuity presents itself I'm going to go to the shiftable SCS. I believe this is the future and hope to see mercury agree. I have spoken to Mercury, and they told me they were looking into it. Seems like a no brainer. With all the technology in the engines etc. the trannie is ancient.
-
11-13-2009 01:49 PM
Also I hold people by what they say. Mercury's refresh says it comes with a 90 day same as new engine warranty.
Well I'm here to tell ya, when I questioned them on this, the response was well we don't replace every part and if its a part we reused then unfortunatly that is not covered by warranty. This is to help keep the cost down to you the consumer. WTF, at this point who gives a ****.
I didn't intend to bring it all up again, but oh well, I did leave the transmission shops name out of it. So please do not delete this thread.
As far as I'm concerned this can be the last post and we'll let it drift down and eventually second paged.
-
11-13-2009 03:29 PM
I'd be ****ed about this for about the next 40ish years or whatever I have left..
I think the original thread shouldn't have ever been deleted and think it should be restored. Why keep other boaters in the dark- thought we were here to help each other?
-
-
- Join Date
- Oct 2008
- Posts
- 4,796
11-18-2009 02:10 PMThe thread was not purposely deleted. It was done during another process and we lost some data. A mistake. If you know me you know I'm not shy about controversy. Both Berman's are my friends and I see both side's perspectives. And I would vouch for either of these guys.
-
-
- Join Date
- Nov 2008
- Location
- Where the summer never ends
- Posts
- 4,346
-
11-18-2009 03:54 PM
This is my house. Business has been good for us too. You should of seen where I lived before this place became available. I broke the skag off my 90 horse Johnson but my neighbor welded it back on for me. I would never buy another Johnson motor or go boating when the lake is shallow.
-
11-18-2009 04:35 PM
Nothing wrong with being trailer trash!
-
-
12-27-2009 10:01 PM
Jeremy, send me a pm. I have a friend with a 46 like yours that's gone through the same tranny problems that you've gone through over this past summer, only he just paid the bill each time. After 3 tranny's and the stbd ones at that, there was a ton a labor charges that he absorbed and now he wants something back. Good story I got for ya.
-
-
12-28-2009 11:13 AM
Jeremy sweet home I love it.
As far as I know those trannies are manufactured by Marc at BAM for Mercury why not call him for the refresh direct?
Also I got Marc's drysump transmissions for the DOI boat I don't recall if it's his sturdiest, I think so and just buying them new was less than $10k for both of them and Marc even gave me core credit I had on two that were lying around in my garage...
Am I missing something here, having not seen Jeremey's thread about Merc re-building them???
-
-
-
- Join Date
- Oct 2008
- Location
- Jax, Fl
- Posts
- 156
01-20-2010 05:29 PMYour house on the lake?
-