Does anyone have experience or know of someone with experience using the extension box for ITS from Zeiger? I know there are some venders here who carry it, but I would like to hear from someone who has actually used it.
http://www.everettperformance.com/Ze...ion_Spacer.asp
Thread: Zeiger ITS extension box?
Results 1 to 9 of 9
-
- Join Date
- Oct 2008
- Location
- Socialist Republic of Washington State
- Posts
- 1,027
11-19-2009 01:56 AM32' Fever (Off to Syracuse) and 36"Gladiator; FORD powered
Cause somebody has to!
-
-
- Join Date
- Nov 2008
- Posts
- 23
11-24-2009 07:39 PMPM JIMKIDMOTORSPORT on here or over on OSO. He has them on his super sweet 30 Skater.
-
- Join Date
- Oct 2008
- Location
- Socialist Republic of Washington State
- Posts
- 1,027
11-25-2009 01:35 AMJust thought of something;
Pushing the drive 5 inches further back is equivlent to dropping the drive about 3/4", Correct?
I know you can raise the X-dimension too but that requires the motor to go up too.
.32' Fever (Off to Syracuse) and 36"Gladiator; FORD powered
Cause somebody has to!
-
- Join Date
- Oct 2008
- Posts
- 1,125
11-29-2009 10:34 AM12 inches back equals 1 inch of drop, so 5 inches would be about 3/8s to a half inch. if your trying to lower the shaft, spacers on the drives will be much less painless dollar wise.
-
-
- Join Date
- Oct 2008
- Posts
- 1,125
-
- Join Date
- Oct 2008
- Location
- Socialist Republic of Washington State
- Posts
- 1,027
11-29-2009 08:57 PMIt was Tres who suggested I go down as well. And he did race a Galdiator.
It is a straight shaft extension. You can raise the outdrive but you must raise the transom mounted engine the same amount.
I already have 2" shorties.
Sounds like you aren't starting out with an ITS?
.32' Fever (Off to Syracuse) and 36"Gladiator; FORD powered
Cause somebody has to!
-
11-29-2009 09:07 PM
After reading your post over again I deleted my post. I see you replied to it already. I thought you were looking for a extension box. You apparently already have the Merc Racing setup and are looking for a 5" spacer. I do not know anything about that product. Let us know what you find out.