What mold was the 40 started off of.. or was it a stretched 32... or a shortened 50...How does the boat ride in the ruff stuff... thanks JEFF
Results 1 to 10 of 10
-
10-03-2009 03:23 PM
-
10-03-2009 03:26 PM
I am not sure about the 40 but didn't they start with the Signature molds years ago.
-
- Join Date
- Jul 2009
- Posts
- 38
10-03-2009 10:23 PMThe 40 is not a stretched 32. It was a new Fiore design. The 40 was 1st Hustler hull with stepped hull.
-
- Join Date
- Nov 2008
- Posts
- 69
10-04-2009 01:05 PMIncorrect.... Paul Fiore with the help of Mark Shneff of Activator went out to design a new 40. They started with the 32 hull and actually bolted the rear 8' of another 32 together. Since the front section of the rear 8' was too wide to fasten to the transom of the 32' they slid it up to the wider part of the transom where it would fit and got the step by accident. They threw a couple of outboards on the hull with no deck and went and tested it and were impressed with what they came up with and how well it performed. That in a nut shell is how and where the 40 came from and the beginning of the step hull.
-
- Join Date
- Jul 2009
- Posts
- 38
-
10-04-2009 09:50 PM
That 40 was built in Patchogue in the original place where mark built Activators later on!Now they build Predators there I may be wrong but I doubt it
-
- Join Date
- Nov 2008
- Posts
- 69
-
- Join Date
- Nov 2008
- Posts
- 69
-
10-04-2009 10:12 PM
I can't resist so I have to say that it started in a glass shop somewhere!!!!
God forgives.....The 1% doesn't!!!!!!
-