Rubrail came loose on one side and the water must have caught it and snapped it off.
Have new rail but I want to make sure I attach this thing right, anybody ever doi them and what do I need? and hows it done?
Appears theres some metal inserts in it and maybe some factory rivets?
Thanks guys
Thread: Broken rubrail fix????
Results 1 to 12 of 12
-
06-07-2009 07:55 AM
-
06-09-2009 01:40 PM
Since you're dealing with the Silent Thunder box, and not the actual hull/deck joint, things will be a little more forgiving; you won't need to make it watertight. Stainless steel sheetmetal screws, probably #10 by 1". The problem might be that the screws that are broken off will be where you want to put the new ones, so you might have to shift your bolt pattern by an inch or two. Just start at one end and work your way around; a heat gun will come in very handy. When you get to the end, remember to cut it long and whittle it down until it fits....
-
06-10-2009 05:35 PM
ah sounds good, thinking of cutting a couple small access panels under the box also and then do a little through bolting.
Rub rail seems like its gonna be a ***** to bend even with heat.
Thanks for the reply.
-
06-11-2009 12:44 AM
off topic, but i noticed your skeg is cut off. does it affect performance?
-
06-11-2009 07:02 AM
Oh god how embarrasing
I was moving the boat in my shop on the trailer with a forklift, forgot drive was down and snapped it off.
Sooo I cut it along the jagged edge that was left and went to the river-havent noticed and difference but now that you mention it????
Should I have a new one welded on? Will it matter ???
Thanks for the input
-
-
06-11-2009 10:55 AM
some of the older race boats had the skegs cut off, im not sure about their reasons for doing it though.
-
- Join Date
- Oct 2008
- Posts
- 907
06-11-2009 11:36 AMThe reason is less drag through the water. A few cats cut off the skegs on the #6 drives then they run a rudder.
-
06-11-2009 04:00 PM
...but at least they ran a rudder. A good jump (intentional or accidental) without one might introduce you to the joys of propwalk. That's an experience you're not likely to forget.
-
06-13-2009 06:23 PMParabellum FJ²B
-
-
06-15-2009 08:18 AM
When the boat comes up high enough out of the water that the only thing submerged is the lower blades of the prop, they can act like a sideways paddlewheel and crab the back of the boat over to one side, so you come down sideways. Normally, the skeg (or a rudder in shaft drive boats) would provide the stability, like feathers on a dart, to keep this from happening. The danger is not as high on boat running low-pitch props, but it can still happen...