Hello,
I am looking to paint a set of "GIL" dry exhaust manifolds. There are a couple spots that are starting to chip, and bubble up a bit. The plan is to bead blast them down, and re-finish them. I have looked into a couple of different high temp paints, however all I am coming up with is an auto parts store bomb can. I would like to paint them in a high gloss red, and I am looking for a higher end paint that will do the job. These manifolds stay relatively cool, even after a hard run??? Any Suggestions???
Thanks in advance,
Jim
Thread: Paint Question...
Results 1 to 2 of 2
Hybrid View
-
02-09-2010 12:54 AM
-
02-09-2010 01:03 AM
PPG's single stage Concept works great on that kind of stuff. . . . . but you knew that
Throttles- Cleveland Construction/Traffic Light Racing 377 Talon cat