Moving drives outboard (wider apart)
Hi All, My original Alpha 1 drive centre´s were about 33". I have taken many measurements from the new engines and the centre´s should be about 37 3/4", allowing 4" between the engines. The TRS transom plates are bigger than the Alpha 1 plates but mostly vertically, the width is not much different. So, I need to move the drive holes about 2 1/2" outboard. Does this mean that I must replace the entire transom or can I build up the inner edge of the existing holes and open out the outer edge of the existing holes?
Either way, what´s the best way to do the job.
Pete