Results 1 to 3 of 3
  1. Collapse Details
    When did Mercury Change this?
    #1
    Geronimo36
    Geronimo36 is offline
    Charter Member
    Join Date
    Oct 2008
    Posts
    3,107
    06-10-2009 05:15 PM
    When did Mercury change the design of the rear bellhousing engine mounts and the lock-washer on Bravo's?

    Just re-rigged a Sea Ray with the 357" Bravo III package and the rear mounts were different and the spiral lock washer is also different than all previous Alpha/Bravo designs.

    it's been a while since a re-rig on one of these so bear with me.
    Reply With Quote
     
  2. Collapse Details
     
    #2
    MOBILEMERCMAN
    MOBILEMERCMAN is offline
    Founding Member / Competitor MOBILEMERCMAN's Avatar
    Join Date
    Oct 2008
    Location
    Lake Travis Texas
    Posts
    6,818
    06-10-2009 05:52 PM
    Some time recently. I just changed them on a 496 and they were s/s to the new pair. Then it mentioned they may be a different height so I changed them on the other motor too. It is fun pressing them out. Looked like Mr Magico holding all the driver and spacer pieces in the press.
    Jim
    Reply With Quote
     
  3. Collapse Details
     
    #3
    Geronimo36
    Geronimo36 is offline
    Charter Member
    Join Date
    Oct 2008
    Posts
    3,107
    06-10-2009 07:47 PM
    Cool, I feel much better! Actually dropped the engine in and used the old washer and noticed the engine was about 1/4 up higher. Put the SS washer in and it lined right up. Haven't seen it yet so it threw me for a loop!

    Thanks Jimmy!
    Reply With Quote
     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules