Results 1 to 3 of 3
  1. Collapse Details
    Kill Switch wiring
    #1
    Tony
    Tony is offline
    Founding Member Tony's Avatar
    Join Date
    Oct 2008
    Location
    Ohio
    Posts
    1,775
    03-31-2009 09:07 PM
    I bought a twin engine single switch kill and have managed to loose the wiring diagram. It has black wires, purple wires, and purple/black wires.

    Anybody know what goes where?
    Reply With Quote
     
  2. Collapse Details
     
    #2
    old377guy
    old377guy is offline
    Charter Member old377guy's Avatar
    Join Date
    Oct 2008
    Location
    Lake Oswego OR
    Posts
    3,740
    03-31-2009 09:11 PM
    Tony, I could make an educated guess, but I imagine you'd like the actual info. - Jeff
    People we meet in life are either a Blessing or a Lesson
    Reply With Quote
     
  3. Collapse Details
     
    #3
    MOBILEMERCMAN
    MOBILEMERCMAN is offline
    Founding Member / Competitor MOBILEMERCMAN's Avatar
    Join Date
    Oct 2008
    Location
    Lake Travis Texas
    Posts
    6,818
    03-31-2009 09:33 PM
    Tony check with an ohm meter.

    You can kill a stern drive by interrupting purple ignition wire at dash. Switch would need to use two wires that have continuity when switch cap is on. And none when cap is off.

    You could also ground ign at motor .That would use two wires that are open when cap is on and has continuity when cap is off.

    I personally like to ground ign method so the purple wire doesn't get switched twice.
    Jim
    Reply With Quote
     

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules