with spring right around the corner. and warmer temps coming soon. who's boats are ready for the water. i can say for the first time in many years mine is all set. only needs a good wash, wax and fuel. well maybe a little warmer wheather. now the baron is another story.
todd
Thread: who's ready??
Results 1 to 20 of 78
-
03-03-2009 08:57 PMBig Seas and Deep Vee's
36' Deep Impact trip 300's, 19' Baron surface drive
Ada Logistics your Flatbed Pro's
-
03-03-2009 09:03 PM
We are expecting 80 degree weather this weekend in S.C. It is supposed to be in the teens tonight. Crazy weather!The boats ready. All I need is fuel.
Bob
-
03-03-2009 09:09 PM
Waiting on sunpad from upholsterer, need to paint drive, cylinders, and gimble ring. Good detail and fuel and I'm in.
-
03-03-2009 09:28 PM
need to install new radio, good wash / wax / detail and gas and were good to go! i would like to build a new subwoofer enclosure also but that can wait a bit.
-
-
03-03-2009 09:46 PM
Need to install lanyard/ign. cutoff, upgrade stereo, replace speedo pitot tube, and spend about a week waxing, buffing, polishing, vacuuming and staring at it...in the driveway.
Also need to replace one trailer taillight and have the wheel bearings checked & repacked.
-
03-03-2009 09:52 PM
Had a high today of 27! However, I got my trip booked to go to PRA St. Pete run at the end of the month! I am not waiting for spring!
-
03-04-2009 08:09 AM
Putting the sleds away this weekend! I need to get started on the boat...putting LED lights in the cabin, replacing dashboard, oil change, gear lube change, wash and wax, new trailer tires....ughh....I've got to get GOING! Although...I still have a good 2 months EASY....
-
03-04-2009 08:25 AM
Mut is rolling...
MTI will be ready end of this month.
-
-
-
-
-
03-04-2009 09:07 AM
Man, I can't wait but we've got a long way to go...still over 3 feet of snow on the ground...and 2 feet of ice on the lake.
As for the Cigarette, all I really need to do is change the sea pumps, wash wax and gas 'er up! My other boats are ready to go, just wash/wax. Hopefully we'll be boating by May.
-
03-04-2009 09:11 AM
I'm not. Haven't even pulled the full cover off and taken the heater out. Of course it was 15 degrees in va last night and we just had a winter "storm", so the motivation isn't there right now
-
-
03-04-2009 02:06 PM
its not even near boatin time yet. I haven't even bought the parts for the new motor yet
-
03-04-2009 02:23 PM
Couple little projects to do, not much to get er ready to splash.
-
03-04-2009 02:26 PM
Although awaiting a decision on what batteries to go with, the old ones are topped off and fully charged and all I have to do is toss them back in the boat and she is ready to go. Supposed to be sunny and low 60's Friday with light winds. She just might get a wet bottom soon!!!
-
03-04-2009 02:33 PM
I am getting really close. I just need to build 2 big blocks, re-rig the boat, add some nav lights, get the trim indicators working, replace the bilge pumps, install a horn, a gps, some oil coolers, repair/replace a hatch, install new control cables. Do a little 12v rewiring. Oh, and drive showers. Oh, and add some braking. Trailer has a single surge. Need 3 wheel electric over hydraulic. Oh yeah... and wash and wax and stare at it.
So.... I am almost there.Warning: This post may contain language unsuitable for minors or math not suitable for liberal-arts majors.