BAMM!
They must have been sitting right in front of Me.
Results 15,261 to 15,280 of 19354
-
04-05-2021 04:40 AMParabellum FJ²B
-
04-05-2021 01:16 PM
Happy Monday
Hope Easter went well for everyone
It was nice, warm, and sunny.
Daughter helped replaced impeller in the outboard.
Not sure if she had much fun, but she was a helper
-
04-06-2021 04:45 AM
Mornin!
Parabellum FJ²B
-
-
04-06-2021 10:54 AM
Headed towards 80 degrees according to the forecasts
-
04-07-2021 05:28 AM
Mornin!
I'm waiting for Bob to put the Snowblower away before I celebrate Summer in Michigan
I f*cked up on a Measurement for a Mobile Home Back Door....a $400 f*ck up...I'm Working for Freeeeeeeeeeeeeeee!!!Parabellum FJ²B
-
04-07-2021 07:20 AM
The plow is off the truck, I put the snow rakes away. I do have the snow shovel still leaning against the side of the garage. My twins were born 4-10-1992 in a blizzard. We are not clear yet.
-
04-07-2021 11:38 AM
I don't want to be the one who F's us all back into winter either...
snow blower is still mounted to the tractor
when the grass gets too tall I will swap it for the mowing deck
Headed towards 80 again today...
-
-
04-08-2021 06:00 AM
Mornin!
I brought My New PQ Home in the Snow , April in Illinois ....Parabellum FJ²B
-
04-08-2021 07:13 AM
We test drove the 290 PQ out of Muskegon on April 15th. It was 80 degrees out. The following week we brought it home. We have pics on Lake Charlevoix with ice still around the edges. We were careful not to hit any icebergs.
-
-
04-08-2021 10:51 AM
My worst was taking my PQ to the upholstery shop to get camper enclosure in a freezing rain ice storm.
Once the Expedition got it up my steep driveway hill, figured that would be the worst of the trip.
-
-
04-09-2021 07:28 AM
I have told this story before. I went on my own dealer trade to pick up a car. My nephew went with me and we towed a uhaul trailer to his dorm room. I had made plans to get a tour of the PQ factory. The parts man (I believe it was Rick) called me when I was almost there. Said they were having a plant meeting ASAP. I never got to stop by, it was the day they called all the employees in and shut down the factory. A very sad day.
-
-
04-09-2021 07:49 AM
Bobcat: I need to set a gate post and there is a 1'x1' section of residential concrete pad in my way. Probably three inches thick. Highly doubt 4. But maybe. I'll be repouring around the post once set. Would you rent a concrete saw, or use an angle grinder and a spud bar? Maybe 14" x 14" the other edge was saw cut as a section. That will get me a spot for my post.
-
04-09-2021 09:45 AM
I guess I could hammer drill a spot out. I have a Hilti TM75
-
04-09-2021 11:51 AM
Good luck with the demo
Happy Friday
Enjoy the weekend
-
04-09-2021 03:02 PM