Got a new drive trim pump tank, want to relocate pump to a different location. To do that will require longer hydrolic lines. On the Brovo 1 drive the lines appear to run through the gimble and to the bottom on the outside to a distribution block. If I pull the block and disconnect the lines will they easily pull out and will new longer lines easily push through, without pulling the motor? I took off the 2 nuts from the block, but it dosen't seem to pull down very easy, any suggestions?
Thread: Removal of trim pump hoses
Results 1 to 13 of 13
Threaded View
-
02-06-2012 12:25 AM