Adjusting engine/coupler

[ICDEDPPL]

Ok still learning about boats so I have a question: I got an alignment tool for the gimbal/engine coupler and it doesn`t line up.
The motor is about 1/2" too high. In the manual it shows adjustable front engine mounts but I don`t have that (unless I`m retarded and they are hidden below somewhere)

My mounts look like this:



so not sure what to do...

[OBNOXUS]

Those are offshore mounts,,,,,non adjustable.

Try moving the bar up or down to pivot the bearing and see if it goes in them

[ICDEDPPL]

Those are offshore mounts,,,,,non adjustable.

Try moving the bar up or down to pivot the bearing and see if it goes in them

That worked like a charm.. now it slides in and out like butter.. SWEET!!!!

[B.Z.]

Those are offshore mounts,,,,,non adjustable.

Try moving the bar up or down to pivot the bearing and see if it goes in them

You are so smart!!!!

[OBNOXUS]

I have my moments

[MILD THUNDER]

I have my moments

Good job

[redhotsommer]

If only you could do ALL your mechnical work via keyboard...you'd be AMAZING. And you'd never have to leave the couch.

[OBNOXUS]

Maybe I wouldnt hate boats so much then !!!!!!