Ok still learning about boats so I have a question: I got an alignment tool for the gimbal/engine coupler and it doesn`t line up.
The motor is about 1/2" too high. In the manual it shows adjustable front engine mounts but I don`t have that (unless I`m retarded and they are hidden below somewhere)
My mounts look like this:
so not sure what to do...
Thread: Adjusting engine/coupler
Results 1 to 8 of 8
-
04-02-2010 07:30 PM
-
04-02-2010 07:45 PM
Those are offshore mounts,,,,,non adjustable.
Try moving the bar up or down to pivot the bearing and see if it goes in them
-
-
-
04-02-2010 08:05 PM
I have my moments
-
-
04-03-2010 09:55 AM
If only you could do ALL your mechnical work via keyboard...you'd be AMAZING. And you'd never have to leave the couch.
-
04-03-2010 10:20 AM
Maybe I wouldnt hate boats so much then !!!!!!