Search:

Props are sold>>>>>>> Please delete post...

Have a right and a left. $500.00 for the pair. Will not split, sorry. Will post pic's if there is any interest.

Didn't they have a rubber washer that went on the bolt on the outside?

Sent you the info. Pete

Answering any Pm's?

Rustoleum does a great job. Looks good.........

White looks great, but make sure you clean or bead blast every weld and nook and cranny. Painted one of my old trailers white, but must have missed a weld or two in the prep. Had a couple rust spots...

Have two sets (four risers). They are modified to a dry configuration. They have 3/8" tubes tig'd into the lower part of the water jacket for drains (can be trimed to fit what you have). Also have...

Pm you this afternoon. Thanks

Showed up today. Nice. Will put it to good use. Thanks Again.........:cheers2:

How about venting some of the engine compartment heat to the helm station. Did that on a older boat I owned (twin setup) via a blower fan. It was not the hottest air but it took the chill away. Pete

PM Sent Thanks Pete

Checks in the mail.............

Second offer..

$80.00 shipped? Thats what J&R sells them for.

Yes sir. That what it sounds like to me. Would order a .005 and give a try. If still sloppy the .010. Look at the bottom of your main caps (the surface were they mount to the block) usually you can...

No doubt the double is the best way to go. But the guy was asking about a single and thats why I give him info on. And yes Bob is a genious and would never doubt any of his sugestions. But for mild...

Yeah if we all had your money.. Ha Ha:seeya:

Plate works just fine. And if not turning 7-8 grand with 700 plus lift, the single chain I mentioned above works great, and fits under the stock cover. Installed dozons and had no failures. Those...

"the single rollers are not as good as a double roller"
Beg to differ on that.....

I run Performance Racing Products part # 9-73388 Billet single with a 9 way crank gear (which I am not the biggest fan of but that the only way they come). Have you had a crank bore alignment done in...

I'll take the other compass. To zip code 97317 Pete Email: terzotrans@msn.com

Sorry it is sold>>>>>>>>>>

Need a set (16) 1.60 ratio BBC 7/16 stud. Stainless only. Cats, Comps, PRW or ? No Procomps please.... Pete terzotrans@msn.com

Agreed. Had a crew cab Ford with 8 inches of lift and 38"s. Have the same set up your uncle built (nice job). After a year of towing, was doing some maintance and found the two front mounting tabs...

s o l d > > > > > > > > > > > > > >