Those still look to be good acceleration numbers even with the drives 3" higher. How deep is your X?
Printable View
Those still look to be good acceleration numbers even with the drives 3" higher. How deep is your X?
Presently I am -3 on that test. The plan is to raise to that height.
I measured this evening.
I got :
4 1/2"inches from top of flame arrester to hatch.
33" centers. Gils
1/4" between manifolds
My outside mounts rise 6" of stringers.
Center stringer 18" height. Mounts stick up 1 1/4 " Perfect.
29 1/2"between stringers.
Engines are 52" long
2 1/4" tailpiece clearance to inside flange.
Wedges under tail piece at gasket surface. I can raise engine and remove wedge, Perfect.
3" to radius at rub rail on transom.
Couldn't be easier to raise drives. Little parts needed. Bunch of labor. I will see exactly how much time.
I might just pull engines and strip the transom tomorrow.
Its actually pretty easy to work on.
I have the tall ones already.
Attachment 74514
Need to find out what the closest center is for headers.
Gonna send my steering back to Latham for re chrome and service, new hoses and such.
Ready to box and label.
Attachment 74521
Attachment 74522
is it margarita time yet? I'll be right over...
Engines out, exhaust off, peeked in a valve cover to see whats there.
Quick clean while Griswald and I drank our margaritas.
Attachment 74524
Attachment 74525
Attachment 74526
I'll clean some more tomorrow, stand the engines up right, pull some parts off. Heads and trannies to start.
Hammer time.
Attachment 74597
Attachment 74598
Attachment 74599
Attachment 74600
Went well, 2 people 30 minutes. 20 lb mall in my hand.
Been a while. Progress is slow and steady. Kinda..
Cleaning parts
Attachment 75283
Attachment 75284
Attachment 75285
Attachment 75286
It took a long time with much patience to remove cork gasket without damaging original paint below.
Attachment 75287
studs I had hammered on came right out with little effort.
Attachment 75288
Attachment 75289
Attachment 75290
Needed to be cleaned. Have new gaskets and screws to re attach.
Attachment 75291
Tabs came off as easily as can be expected. Didn't even scratch the paint.
Attachment 75292
There is corroded aluminum where the gasket held moisture. It appears the mointure came from inside the boat. The cavity where the trim lines go thru the assembly holds water. I think if that water was allowed to drain there would have been no corrosion. Over all they are in great shape. The pins and bushings are tight and the gimble ring has not dropped.
Attachment 75293
Getting the sealant off without damaging the paint will take some effort. Chances are good I will remove the pins and paint as necessary.
Need to cover and prepare the boat for grinding.
Attachment 75294
Still need to decide whether or not to relocate the steering mount location. They are pretty close to where they need to be. The where actually a little high for the previous set up.
love to see this stuff, Jim. Did you fab your own steering mount plates on the drives?
No, the ones shown above are latham. The boat was original built with Latham add on steering. A couple years later Latham created a rear mount plate for TRS. I am going to use them. The plates and clevis joints will be one of few actual up dates. The original rod ends on the rams and tie bar were wore out. I wish to keep the boat as close to "as it left the factory" as possible.