View Full Version : can anyone help me with trs alingment tool
43 scarabthunder
04-24-2012, 12:38 PM
im having the alingment bar made but need to find the dimesions of the disc for the trs please if anyone can tell me dimesions be much appreciated asap :willy_nilly:
old377guy
04-24-2012, 06:53 PM
I have a TRS service manual but doubt it gives dimensions (don't have it right here or I'd check). Mobilmercman - Jim probably knows.
MOBILEMERCMAN
04-24-2012, 08:42 PM
Guess measure the hole where the drive mounts and again just within the studs. I can dig out my tool and measure later if need be.
MOBILEMERCMAN
04-24-2012, 09:20 PM
The tool part number is 91-57797a3 $138.25
Seems like it would cost more to make one.
Anyway. Largest diameter 4.88
next 4.52 with .25 shoulder
3.83 with .46 shoulder
Good luck
Rookie
04-27-2012, 09:44 PM
http://www.boatfix.com/merc/Bullet/92/92_09.pdf
old377guy
04-28-2012, 11:59 AM
Jason, be sure to give us some updated pix when you get the motors re-rigged
43 scarabthunder
04-29-2012, 11:34 PM
Thanks for the help!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.