PDA

View Full Version : SVL in Cocoa Beach



Pete B
05-17-2011, 10:38 AM
what SVL's will be in Cocoa Beach.

600sci
05-17-2011, 02:17 PM
what SVL's will be in Cocoa Beach.

i heard 5 so far !

IMCO
ACTIVATOR
DOC
Simmons
Steve

SVL66
05-17-2011, 02:50 PM
i heard 5 so far !

IMCO
ACTIVATOR
DOC
Simmons
Steve



not sure about that

i dont think Simmons will be there. They still have some work to do on their boat. And I'de be surprised if the Fountain showed.

extras
05-17-2011, 06:05 PM
not sure about that

i dont think Simmons will be there. They still have some work to do on their boat. And I'de be surprised if the Fountain showed.

I agree I heard the Fountain is afraid to race the activator

SVL66
05-17-2011, 07:39 PM
I agree I heard the Fountain is afraid to race the activator

I heard the same thing...so it must be true:26:

heater63
05-17-2011, 11:00 PM
Go get em Mark!

600sci
05-17-2011, 11:26 PM
well, not sure about Simmons..sorry to hear ..but i did hear Doc will be there !

XtremeRacing
05-17-2011, 11:47 PM
I dont think you will see the Fountain SVL in Cocoa, Doc might be there but he will be running with Dan .

imco offshore
05-18-2011, 07:32 AM
yea with an engine rule and an x dim rule ( 1/2 below ) it probably wouldn,t work out,,

600sci
05-18-2011, 07:57 AM
I dont think you will see the Fountain SVL in Cocoa, Doc might be there but he will be running with Dan .

gotcha, thought he would bring the SVL !:seeya:

Slandrew
05-18-2011, 07:59 AM
I agree I heard the Fountain is afraid to race the activatorI think you heard wrong:huh:

XtremeRacing
05-18-2011, 08:14 AM
George,

Are you ready to rock budddy....

extras
05-18-2011, 12:53 PM
I think you heard wrong:huh:

No its true

Ratickle
05-18-2011, 03:57 PM
No its true

I heard the same thing......:03::D:03:

imco offshore
05-18-2011, 07:56 PM
George,

Are you ready to rock budddy....

NO :willy_nilly:

XtremeRacing
05-18-2011, 09:42 PM
Sorry to here that if there is anything i can do to help get me know,you will be missed.

ccracing
05-19-2011, 12:16 AM
Hope we make it gang!!! Were trying!!

jonesn'
05-19-2011, 06:42 AM
Good luck this weekend guys!

SVL66
05-19-2011, 07:50 AM
NO :willy_nilly:

New motor, new drive, new seats. Tested a couple times. Boat was supposedly running awesome....and your not ready? whats up with that?
Things that make you go HMMMM!

XtremeRacing
05-19-2011, 08:00 AM
Bruce,

I think George has an oil leak he has be chasing all week. Seems like he has checked just about everything and cant seem to find it. Not really sure if anything has change other then that the last few days .

rchevelle71
05-19-2011, 08:20 AM
Bruce,

I think George has an oil leak he has be chasing all week. Seems like he has checked just about everything and cant seem to find it. Not really sure if anything has change other then that the last few days .

Tell him to bring it over, and we'll find it and put some chewing gum on it so he can race:reddevil:

imco offshore
05-19-2011, 11:02 AM
the engine was rebuilt ( rings and Bearings gaskets and seals only) i ran it on break in oil 40w ran the engine up to 4000 rpm,s for about 1/2 hour ,,everything ran great ,,went back to the shop ,changed the oil and filter ,went out again with the new driver ,ran it all out 5450 on the limiter ,,the boat was fast ,,so we stoped and looked into the bilge , and found about 4 qts of oil in front of the engine ,,,logic would dictate the only thing you changed was the filter ,,so i put on a new one ,,went back out ,,with the same results ,,,sugestions from great people ,,,timing cover seal ,,changed twice,,timing cover gkt,,changed ,,no help ,,,check bolt holes in front of engine ,,none open nor leaking,,, it does not do it on the hose ran up to 5000 until i ran out of water pressure,, so ,,if someone is suggesting foul play , i would gladly welcome you or anyone you might know to come down and run this boat,or gladly would listen to any more suggestions ,the critics might have,,,thanks in advance hhmmmmm

ccracing
05-19-2011, 12:24 PM
If we don't make it over, enjoy yourselves because we will soon be running you boyzz!!! Lol everybody be safe and enjoy!!

rchevelle71
05-19-2011, 12:49 PM
If we don't make it over, enjoy yourselves because we will soon be running you boyzz!!! Lol everybody be safe and enjoy!!


What do you mean if you dont make it?? We were looking forward to the challenge:reddevil:

Ratickle
05-19-2011, 01:45 PM
the engine was rebuilt ( rings and Bearings gaskets and seals only) i ran it on break in oil 40w ran the engine up to 4000 rpm,s for about 1/2 hour ,,everything ran great ,,went back to the shop ,changed the oil and filter ,went out again with the new driver ,ran it all out 5450 on the limiter ,,the boat was fast ,,so we stoped and looked into the bilge , and found about 4 qts of oil in front of the engine ,,,logic would dictate the only thing you changed was the filter ,,so i put on a new one ,,went back out ,,with the same results ,,,sugestions from great people ,,,timing cover seal ,,changed twice,,timing cover gkt,,changed ,,no help ,,,check bolt holes in front of engine ,,none open nor leaking,,, it does not do it on the hose ran up to 5000 until i ran out of water pressure,, so ,,if someone is suggesting foul play , i would gladly welcome you or anyone you might know to come down and run this boat,or gladly would listen to any more suggestions ,the critics might have,,,thanks in advance hhmmmmm

Then I'm going with blowby...

Anyway, if I were closer, I'd ride in the engine compartment while you were hammering on it and figure this out for you.....

Slandrew
05-19-2011, 03:39 PM
Hope it's a great turnout!Post some pictures & results!

TYPHOON
05-19-2011, 06:15 PM
Check oil filter and make sure the gasket is there or that you dont have the old one still on giving you 2 gaskets.
MD

imco offshore
05-19-2011, 07:59 PM
thanks Randy ,,but i,m on my 3rd one ,,i did not hone the block ,,i used a dingleberry to knock off the glaze ,for the new rings ,,i,m afraid they did not seat in ,,,i,m doing a leak down test in the am ,,
ps congrats on your great ,finish last year and a better start this year ,,keep it up,,hope we can all get together again ,like old times ,,could you see ?
PIRATE,MEZO,,BRUCEEE,,WILLIE,,OCTANE,,TYPHOON,,SUNPRINT,,IMCO,,
PIG IRON,,WILDRIDE,,,ACTIVATOR,,,,,,,,,ALL IN A LINE-UP ,,Hell in this day and age we could be our own ORG ,,,lololo JOKING PEOPLE,,,,THANKS FOR EVERYONES INPUT IT DOES HELP,,:huh:

MOBILEMERCMAN
05-19-2011, 09:04 PM
Put a camera in the bilge.

I was found a water leak only after removing the hatch and riding in the bilge at speed. I found the water was marching UP AND FORWARD on a tail pipe and landing on the intake.. I was watching it and couldn't believe it.. I experienced a HELL ride once in a bilge at a 100 mph. Now I believe a camera in the engine bay is better than a body.

imco offshore
05-20-2011, 04:46 PM
yea ,,i,m not getting in the bilge ,,,but ,,I pulled the engine ,,started tearing down the pumps ,,pullys,,tanks ,,ect ,,,got to the timing cover ,,looked at it real close ,,what looked like a paint run ,,turns out to be cracked around the seal to oil pan ,,and the oil is being forced out by blow-by,pressure,,,i don,t think the rings are seated yet ,,,

SO WHAT DO I DO ?? KEEP GOING and replace the rings ,,or replace the timing cover and run in the rings ??

XtremeRacing
05-20-2011, 07:36 PM
George,

Testing tomorrow and i still need that secert weapon prop you were bring for me ...lol

Phantom1
05-20-2011, 09:26 PM
Here ya go....

imco offshore
05-20-2011, 09:46 PM
Here ya go....

that is way to funny ,,great banner ,,get his excuse before the race ,,we know he has a life time of them,,,,

ccracing
05-21-2011, 12:10 AM
nice!!!! sorry george and i couldnt make it, im totally bummed!!! we will be there next time gang so be ready!!!!! good luck too all....

heater63
05-21-2011, 02:25 PM
I love the banner,might just as well bring it to all the races.Just change the location.

Ratickle
05-22-2011, 12:59 PM
Are just Mark and Steve running there?

Ratickle
05-22-2011, 05:09 PM
Just received a PM from Cocoa Beach.....



Looks as if the Activator is the official winner of SVL. Steve only made it for 9 of the 10 laps, Mark finished them all.


Congratulations Mark, 3 years of hard work and testing paying off.......:hurray::hurray::hurray:

Mark in the Activator last year in Michigan City...

http://i730.photobucket.com/albums/ww310/ptrose/SBI%20Michigan%20City%202010/p48.jpg

imco offshore
05-22-2011, 05:58 PM
great turn out ,good racing,,,congrads to Mark and Frank ,,Steve ,,somewhere along the line,,, missed mileage ,,( we,ve all done it ) the race was 10 laps 54 miles on a 5,4 mile course,,,as they crossed the start finish line,, the onboard gps read 56,?? miles ,,so I think they assumed the race was over,,,only to see Mark And Frank bolt by and fade off into the distance to catch the first checkerd flag of the SBI SVL SEASON,,, the Cat Outboards put on the best race i,v seen in a long time,,great job teams ,,my 2 cents

XtremeRacing
05-23-2011, 08:08 AM
Thanks George....We had a great weekend sucked that u couldnt make it. See you in Sarasota .