Transom wedge for NXT/Number 6?

[C_Spray]

Does anyone make a wedge for nosing the engine down when installing a #6 or NXT? (I'm actually installing an Ilmor Indy drive, but the pattern is the same.) If I can nose the engine down, it will help with some header clearance issues that I am facing. Basically, I need the front face/flange of a standoff box, at least 1" thick so I can get 2 or 3 degrees from it.

[DAREDEVIL]

Does anyone make a wedge for nosing the engine down when installing a #6 or NXT? (I'm actually installing an Ilmor Indy drive, but the pattern is the same.) If I can nose the engine down, it will help with some header clearance issues that I am facing. Basically, I need the front face/flange of a standoff box, at least 1" thick so I can get 2 or 3 degrees from it.

YES.....but i don't remember who,,but i can find out for u and give u a # !!!!!

[C_Spray]

That would be great. I looked at making one, and the material alone was going to set me back a few hundred...

[C_Spray]

So far, I'm chasing down leads at BAM Marine and Skater.

Nothing from IMCO, Stellings, or Mercury????

[Sydwayz]

Check with Teague and Lip-Ship.

They have both experimented with making their own setbacks.