PDA

View Full Version : Paint Question...



251Convincor
02-09-2010, 12:54 AM
Hello,


I am looking to paint a set of "GIL" dry exhaust manifolds. There are a couple spots that are starting to chip, and bubble up a bit. The plan is to bead blast them down, and re-finish them. I have looked into a couple of different high temp paints, however all I am coming up with is an auto parts store bomb can. I would like to paint them in a high gloss red, and I am looking for a higher end paint that will do the job. These manifolds stay relatively cool, even after a hard run??? Any Suggestions???


Thanks in advance,


Jim

glassdave
02-09-2010, 01:03 AM
PPG's single stage Concept works great on that kind of stuff. . . . . but you knew that :D