PDA

View Full Version : Dash gauge holes



ItsPeanut
01-05-2010, 05:42 PM
Want to patch gauge holes. Any suggestions on materials and glass type.

Offshore Ginger
01-06-2010, 08:31 PM
Hey .................. whats up? I , just did a dash using Epoxy basically using multiple layers of 10 oz chesse cloth on the outside of the dash , S glass for the back side or you can use 1708 along with plywood hole saw cut outs to fill in the gauge holes , and other then going on and on .......... what type of resin are you thinking of using Epoxy or ...................

Geronimo36
01-14-2010, 06:30 PM
Dave did a thread about this on OSO a few years ago.. It's come to the top just recently.

Offshore Ginger
01-14-2010, 06:45 PM
Dave did a thread about this on OSO a few years ago.. It's come to the top just recently.Frank i was going to post it here but i thought i would leave that up to Dave.

ItsPeanut
01-14-2010, 08:07 PM
yea, i seen it over their, thanks

J-Bonz
01-14-2010, 08:34 PM
yea, i seen it over their, thanks

If you need any glass, I can send ya some..
Jr.